顺序采样器 TSP颗粒物采样器

微信扫码

ILIFETEK空气中悬浮颗粒物（TSP）顺序采样器
LIFETEK PTS 允许空气中县浮颗粒物（TSP）自动
顺序（序列）采样

特点

• 封闭柜式机箱，避免外部干扰，防止风化

• 可用在固定台站，也适合安装在移动设备上

• 工作流量5-70L/min带电子负载损失自动补偿

• 带滤膜压降、环境温度、大气压测量传感器

• 时间采样和流量采样

• 干式体积流量计，最大误差±2%

• 立即采样、定时采样、可编程采样

• 断电保护、来电自动恢复、事件记录

• 报警

• 诊断

• USB接口

• GMS 远程遥控模块（可选配）

• 容量：16P

• 膜尺寸：47mm

PTS SAMPLING SEQUENTIAL SAMPLING SYSTEM

The system LIFETEK PTS to carry out PTS total dust sequential samp领 is supplied in a cabinet suitable to store all relevant components and it is made to grant optimal protection against atmospheric agents; the configuration suitable for the installation on mobile devices is also available.

The sampler operation range is 5 to 70 l/min and it is equipped with an electronic system for the automatic compensation of the losses of load. It is also equipped with sensors for the measurement of the pressure fall on the filter,and of the flow meter temperature. The volume is measured through volume dry flow meter with ± 2% max error.

Through the data programming and control module it is possible to fix the samp领 timing or its flow, the suction flow,the initial delay, the duration of the breaks and the operation diagnostics.

All the data related to the samp领 are automatically stored and can be transferred to a USB pendrive.

In case of power failure interruption, the system stores the sampled data acquired, records the event and grants the restart of the operation when the supply is restored.

The samp领 system is set to use the GSM (optional) mode for the remote control of the samp领 and of the alarms through a text message.

MODULE SELECT 8 The sequential module allows the automatic pick up of the total dusts on ? 47 mm filters.Operational autonomy is 8 filters.