405nmUV LED 日本日亚NCSU035C原装

微信扫码

日本日亚405nm 6868 365nm 平窗120石英玻璃片封装  3D打印机固化灯

参数

 电流 Forward Current 700mA

电压 Forward Voltage   3.5-3.9V

电功率 Power Dissipation 3.08W

光功率 Radiant Flux 800mW/cm2

峰值波长 Peak Wavelength 405nm

封装尺寸：6868    6.8*6.8*1.9 L*W*H(mm)

询问中文详细规格书可以联系我，先看原文件截图

散热和焊接使用注意事项，需要中文的直接联系我简妮15989862032

 Thermal Management
● The Absolute Maximum Junion Temperature (T J ) must not be exceeded under any circumstances. The increase in the
temperature of an LED while in operation may vary depending on the PCB thermal resistance and the density of LEDs on the PCB
embly. Ensure that when using the LEDs for the chosen application, heat is not concentrated in an area and properly managed
in the system/embly.
● The operating current should be determined by considering the temperature conditions surrounding the LED (i.e. T A ). Ensure that
when operating the LED, proper measures are taken to dissipate the heat.
● The following two equations can be used to calculate the LED junion temperature:
1) T J =T A +R θJA ?1?1W 2) T J =T S +R θJS ?1?1W
*T J =LED Junion Temperature: °C
T A =Ambient Temperature: °C
T S =Soldering Temperature (Die Heat Sink): °C
R θJA =Thermal Resistance from Junion to Ambient: °C/W
R θJS =Thermal Resistance from Junion to T S Measurement Point: °C/W